РУССКИЙ
ENGLISH
Installation of enamel reactor
Installation of enamel reactor
1) Handling:
During transportation, only the tank ears are allowed to bear force (referring to non-packaging), and rolling and crowbars are not allowed to avoid vibration and collision. It is strictly forbidden to bear force on vulnerable parts such as pipe collars and clips.
2) Hoisting:
When hoisting, wire ropes must be hung at specified positions (such as jacket joints, tank ears, etc.). (The lifting ring on the tank cover is only used for hanging the tank cover), and it cannot touch any object, and it should be hung steadily and put down gently.
3) Inspection before assembly:
Before assembly, inspectors should wear clean soft-soled rubber shoes and enter the container to check whether there is any abnormality in the glass-lined layer.
4) Flange installation:
When tightening the flange bolts, they should be tightened gradually in pairs along the diagonal, and the force should be uniform, and should not be fully tightened at one time, so as to avoid the cracking of the glass-lined layer due to uneven force.
service life.
5) Installation of clips:
It should be checked first whether the clips are complete and whether the quantity meets the requirements. During installation, ensure that the distance is even and the tightness is appropriate to ensure safe operation and reliable sealing.
6) Installation of the mixer:
a. First put the agitator into the tank (the bottom of the tank is covered with a cushion), then lift the tank cover to the predetermined position, and at the same time put the seal on the agitator shaft, and then lift the agitator to the output shaft of the reducer
Connect and lock the anti-loosening device.
b. Adjust the coaxiality and verticality of the stirring shaft and the seal, and make the stirring shaft rotate slowly after reaching the requirements of the technical regulations. When the operation is flexible and there is no abnormal phenomenon, it is allowed to try to open again
Press the motor button until it runs normally (this period of time should not be too long).
7) Choice of pad:
It must be selected according to the type, concentration and temperature of the medium. The nature and use of the gasket itself should be suitable for the process requirements. The gaskets currently supplied by our factory include asbestos rubber,
Rubber outsourcing PTFE is available for users to choose.
8) Welding:
a. It is strictly forbidden to apply welding on the surface of the outer wall of the glass-lined tank.
b. When welding the connecting pipe, tank ear and tank seat on the jacket, electric welding shall be used and cooling measures shall be taken, and gas welding shall not be used.
c. When welding the space near the glass-lined layer, the glass-lined surface, tank mouth, and nozzle should be tightly covered to avoid splashing of welding slag and damage the glass-lined surface.
Latest News
Contact Us
Name: Ivan
Tel: +86 533 5580757
Mobile/Whatsapp: +86-13054986747
E-mail: [email protected]
WeChat: +86-13054986747
Whatsapp: +86-13054986747
Add: No.7 Zhangdian High-tech zone, Zibo City of Shandong province, China
WhatsApp 
Mail inquiry