<< Back

The outer coil heat transfer stainless steel reaction kettle has two kinds of electric heating and steam heating, the two ways are in the reaction kettle with a layer of jacket outside the simplified, in the jacket to produce high temperature heat transfer medium to provide heat for the kettle material. There is an electric heating rod inside the jacket of the electric heating reaction kettle, and then the heat conduction oil is injected. When working, the power supply of the electric heating rod is switched on first, and the electric heating rod is used to generate heat to improve the temperature of the guide oil, and the heat conduction oil is transferred to the inner body. Increase the temperature of the stainless steel material in reaction kettle manufacturer with rapid heating, high temperature resistant, corrosion resistance, health, no environmental pollution, there is no need to boiler, automatic heating, convenient use, etc, are widely used dry oil, chemical, rubber, dyes, food, used to complete the vulcanizing, nitration and ammoniation, alkylation, polymerization, condensation process, In order to participate in the reaction of the substance is fully mixed as the premise, for heating, cooling, and liquid extraction and gas absorption, such as physical change process need to use stirring device to get good results.

Operation rules for external coil heat transfer stainless steel reactor: stainless steel reactor before operation

1. Check whether the kettle, stirrer, rotating part, auxiliary equipment, indicating instrument, safety valve, pipeline and valve meet the safety requirements.

2, check whether the water, electricity and gas meet the safety requirements. Stainless steel reactor in operation

1. The stirrer of the reactor should be turned on before feeding. When there is no noise and it is normal, the material should be added to the reactor, and the amount of feeding should not exceed the process requirements.

2. Before opening the steam valve, first open the return valve and then enter the valve. The steam valve should be opened slowly to preheat the jacket and gradually increase the pressure. The pressure in the jacket is not allowed to exceed the specified value.

3, steam valve and cooling valve can not be started at the same time, steam pipe passing gas is not allowed to hammer and collision.

4. When opening the cooling water valve, first open the backwater valve and then enter the water generation. The cooling water pressure shall not be lower than 0,1 water pa, nor high dry 0,2 water pa.

5, water ring vacuum pump, to start the pump before the water supply, stop the pump, stop the pump after the water, and should remove the water in the pump

6. Check the operation of the reactor at any time, and stop the reactor for maintenance if any abnormality is found.

7, stainless steel reactor after stopping 1, stop stirring, cut off the power supply, close all kinds of valves.

2. When shoveling the pot, the power supply of the blender must be cut off, the warning board should be hung, and someone should monitor it.

3, stainless steel reactor must be carried out regular technical inspection according to the requirements of the pressure vessel, the inspection is not qualified, shall not run.